The Process

How It Works

Three steps. No guesswork. A match that lasts.

Built for the Field, Not the Lab

Pioneer Masonry StainKit uses iron oxide pigments suspended in a breathable silicate binder — the same chemistry used in historic preservation work for over a century. The result penetrates the brick face rather than sitting on top of it, so it won't peel, chip, or fade with freeze-thaw cycles.

The process is straightforward: clean the surface, mix your color, apply with a brush or sponge, and let it cure. No special equipment. No contractor required. Just the right materials and a little patience.

Mix Your Color
01

Mix

Mix Your Color

Start by selecting your pigments and mixing them into the provided silicate base. Work in small batches — a tablespoon of pigment per cup of base is a good starting point. Test on a scrap brick or an inconspicuous area first, let it dry fully, and adjust the ratio until you've nailed the match. Iron oxide darkens slightly as it dries, so always let your test patch cure before committing.

Pro Tips

— Mix in natural daylight — artificial light shifts color perception.

— Keep a written record of your ratios for touch-ups later.

— Use a digital kitchen scale for repeatable results across batches.

Apply to Clean Brick
02

Apply

Apply to Clean Brick

Brick must be clean, dry, and free of efflorescence, paint, or sealers before application. Use a stiff-bristle brush to work the stain into the surface in circular motions, then feather the edges with a damp sponge to blend. Work one brick at a time on detailed repair work, or in 2–3 square foot sections for larger field areas. Avoid application in direct sun or temperatures below 40°F.

Pro Tips

— Dampen the brick slightly before applying — it slows absorption and gives you more working time.

— Feather edges while wet; blending after drying is much harder.

— Two thin coats beat one heavy coat every time.

Cure and Protect
03

Cure

Cure and Protect

Allow the stain to cure for a minimum of 24 hours before exposure to rain or heavy moisture. Full silicate cure takes 7–10 days, during which the binder chemically bonds with the silica in the brick face. After full cure, the stain is permanent and breathable — no topcoat or sealer is needed or recommended, as sealers can trap moisture and cause spalling over time.

Pro Tips

— Avoid covering or wrapping treated brick during the cure window.

— Light rain after 24 hours is fine; heavy rain in the first 12 hours can dilute the binder.

— Do not apply a sealer — the silicate binder is the finish.

Before You Start

  • Test on a hidden area first — always.
  • Clean brick thoroughly; efflorescence and dirt prevent penetration.
  • Work in shade or on overcast days for the most accurate color read.
  • Have extra pigment on hand — matching a second batch is harder than mixing enough the first time.
  • Document your mix ratios in writing before you start applying.

Ready to Match Your Brick?

Both kits ship with a full mixing guide, pigment reference cards, and application instructions. If you have questions about your specific brick type, reach out before you order.

Pioneer Masonry StainKit

Professional-grade brick stain kits built by a master mason with over 20 years in the field. Match any brick. Get it right the first time.

Trusted by masons since 2003

Get in Touch

Questions about matching your brick? Need a custom blend recommendation?

Contact Us →

© 2026 Pioneer Masonry Restoration, LLC. All rights reserved.

PioneerMasonryRestoration.com